5
5.5. Dual Time settings and display
•
Dual Time allows you to set and display a second, completely
independent time (8).
•
Press the
MODE
button (4) repeatedly until
SECOND TIME
is displayed.
•
Press and hold the
MODE
button (4) for approximately 3
seconds. The hours display begins to flash.
•
Press the
▲
button (3) or the
button (2) to select the hour
and confirm your selection by pressing the
MODE
button (4).
The minutes display begins to flash.
•
Repeat the process to set the minutes.
•
To select the individual values, press the
▲
button (3) or the
button (2) and confirm each selection by pressing the
MODE
button (4).
5.6. Backlight
If you press the
LIGHT-SNOOZE
button (11), the display will light
up for approx. 5 seconds.
5.7. Projection
Activating/deactivating
Power supply from
batteries
• Press the
LIGHT-SNOOZE
button (11) to project the display onto
the wall or ceiling for five seconds.
Power supply from
bat mains:
• Slide the
CONTINUE PROJECTION
sliding switch (9) up
towards to set the projection to sustained mode.
• Slide the
CONTINUE PROJECTION
sliding switch (9) down/
away from to deactivate sustained mode.
Projection settings:
• Turn the projection arm (8) forward/back to project the display
onto the wall or ceiling.
• Press the
FLIP
button (7) to rotate the projection by 180°.
• Turn the
ROTATE
control dial (12) to further rotate the projection
by up to +/–90°.
• Turn the
FOCUS
control dial (13) to focus the projection.
• Press and hold the
FLIP
button (7) for approx. 3 seconds to
switch the projection between displaying the time and displaying
the time and temperature.
Note – Projection
•
At a distance from the projection lens to the wall/ceiling of
about 2 m / 4 m, the size of the display projection on the wall
is about 10 cm / 18 cm.
•
By default, the projection shows the time. See the instructions
above to set the projection to alternate between the time and
the temperature.
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do
not use aggressive cleaning agents. Make sure that water does not
get into the product.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating
instructions and/or safety notes.
8. Technical Data
RCR 110 radio-controlled alarm clock
Power supply
5.0 V
2 x AA batteries
Power supply unit:
In: 230 V
50 Hz
Out: 5 V
130 mA
Measuring range
Temperature
0°C – +50°C/ 32°F – +122°F
9. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio
equipment type [00104952] is in compliance with
Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet
address: www.hama.com->00104952->Downloads.
Frequency band(s)
77,5 kHz