Hama DS-200, Operating Instruction

Page: 6 / 10

10 11
When the magnetic contact
is closed, the receiver will
not beep.
When the magnetic contact is
broken (open), the receiver will beep
and a LED will flash.
Magnet Magne “Red Marking”
on the side
Magnet
Sensor
“Red Marking”
on the side
Sensor
Mounting plate and
screws (optional)
Double-sided
foam tape
Sensor
Step 4:
You will hear a long beep and the zone LED stops flashing. The sensor is now
programmed to the Control Panel.
Note: You may program up to 4 sensors to one zone.
Zone 4 is an alert zone, sensors in this zone is fort alert purpose ONLY and
will not trigger the alarm.
Test Sensor
After learning the sensor to the control panel, you may test the communica-
tion by placing the magnet beside the transmitter (where the red marking is)
and remove the magnet from the transmitter.
1.Zone LED of this sensor will flash
2.Beeping according to the zone number (Alert Notification Switch is set
to “Alert”). 1 beep for zone 1, 2 beeps for zone 2 etc., until the sensor is
closed.
Note: If the Alert Notification Switch is set to “Chime”, Control Panel will
chime once for every signal activation. If the Alert Notification Switch is set
to “OFF”, no audio alert will sound.
3. Installation
The transmitter should be mounted on the door frame or window frame by
double sided tape. The magnet should be mounted on the door or window
by either double sided tape or screws. Make sure the magnet is aligned with
the red marking on the transmitter. If the surface of the frame is flat enough,
double-sided foam tape is sufficient, otherwise, it is recommended to screw
the mounting plate to the frame, then apply double sided tape. After mounting
the sensor, if the Skylink logo is inverted, remove the front cover and rotate it
so the Skylink logo is in the upright position.