7
Warning – Batteries
•
When inserting batteries, note the correct polarity
(+ and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking
or exploding.
•
Only use batteries (or rechargeable batteries) that match
the specified type.
•
Before you insert the batteries, clean the battery contacts
and the polar contacts.
•
Do not allow children to change batteries without
supervision.
•
Do not mix old and new batteries, or batteries of different
types or from different manufacturers.
•
Remove the batteries from products that are not being
used for an extended period (unless these are being
kept ready for an emergency).
•
Do not short-circuit batteries.
•
Do not charge batteries.
•
Do not burn batteries.
•
Keep batteries out of the reach of children.
•
Never open, damage or swallow batteries or allow them
to enter the environment. They can contain toxic,
environmentally harmful heavy metals.
•
Remove spent batteries from the product and dispose
of them without delay.
•
Do not store, charge or use the device in extreme
temperatures.
4. Informations and notes before getting started
Note
A detailed description of the UNDOK app and all of its
functions can be found in our UNDOK guide at:
www.hama.com->00054893 ->Downloads
Note
•
For best reception, ensure that the antenna is fully
extended and vertical.
•
Try various different positions if necessary to get the
best reception.
Network connection / Preparing the Internet
connection
You can integrate this radio into a network. To receive
Internet radio, an Internet connection is required on this
the network.
WLAN connection (wireless network)
•
Ensure the router is switched on, is functioning correctly
and that there is a connection to the internet/network.
•
Activate the WLAN function of your router if it is not
already activated.
•
Follow your router's operating instructions as regards
the correct functioning of the WLAN connection.
Note
Use only original accessories (or accessories approved
by Hama) to avoid damage to the product.
5. Getting started
Warning
•
Only operate the product from a socket that has been
approved for the device. The socket must be installed
close to the product and must be easily accessible.
•
Disconnect the product from the power supply using
the On/Off switch – if this is not available, unplug the
power cord from the socket.
•
If using a multi-socket power strip, make sure that the
total power consumption of all connected devices does
not exceed the power strip's maximum throughput rating.
•
If you will not be using the product for a prolonged
period, disconnect it from mains power.
5.1 Remote control
•
Open the battery compartment cover located on the rear
of the remote control.
•
Insert the batteries provided, making sure you match
the polarities correctly. The correct polarity is indicated
by the plus and minus symbols in the battery compartment.
