4
4. First steps - Inserting the batteries
Note
•
Alkaline batteries are recommended. Use two batteries of the type "AAA"
(LR 03/Micro).
•
Remove the battery cover on the back of the universal remote control (A).
•
Insert the batteries, observing the "+/-" marks for polarity (B).
•
Close the battery compartment (C).
Note: Code memory
•
Each programmed code or taught-in button is retained even during battery
replacement.
Note: Energy saving function
•
The remote control switches itself off automatically if a button is pressed for
longer than 15 seconds. This prolongs the life of the batteries if the remote
control is stuck in a place where the buttons are pressed permanently, e.g.
between sofa cushions.
Note: Low battery display
•
This remote control indicates when the batteries are getting low.
If the status LED flashes 5 times after a button is pressed, the batteries are
weak and should be replaced promptly.
5. Setup
Note
•
For proper infra-red transmission, always hold the remote control in the
approximate direction of the device to be operated.
•
If no entry is made within 30 seconds, SETUP mode is automatically
terminated. The LED flashes three times and then goes out.
•
Each type of device can be programmed under any device button, e.g. a TV
can be programmed under DVD, AUX, etc.
•
You cannot operate a device with the universal remote control while it is in
Setup mode. Exit Setup mode and select the device to be operated using
the device selection buttons.
•
Please note that the remote control emits infra-red signals. These are not
visible to the human eye.
•
Each time the button is pressed, the status LED flashes to indicate which
device mode is active.
Summary of Contents for 00040074
Page 2: ......
Page 3: ...Art Nr 00040074 6in1 2 5 3 6 8 12 11 9 7 4 10 21 20 19 22 17 18 15 13 16 14 1 SOUND AAA ...
Page 26: ...24 ...
Page 203: ...201 ...
