Hama 00040074, Operating Instructions Manual

Page: 9 / 204

7
5.4 Code recognition
Code recognition offers you the ability to determine a code you have already
saved.
5.4.1 Press the "SETUP" button until the LED lights up continuously.
5.4.2 Use the device button to select the device to be operated (e.g. TV).
If the selection is successful, the LED flashes once and then lights up
permanently.
5.4.3 Press the "SETUP" button. The LED flashes once and then lights up
permanently.
5.4.4 Press one of the number buttons from 0 to 9 to search for the first digit.
The LED flashes once for the first digit of the four-digit code number.
5.4.5 Repeat step 5.4.4 for the second, third and fourth digits respectively.
5.4.6 You can then enter the determined code in the table below if you need it
again at a later time (e.g. after accidentally deleting the remote control
settings).
CODES
TV SOUND STB
DVD AUX DVBT
6. Special functions
6.1 Channel punch-through
With the channel punch-through function, the Ch+ or Ch- commands can bypass
the currently controlled device and change the channels of a second device. All
other commands are unaffected.
6.1.1 To activate the channel punch-through function:
• Press and hold the [MUTE] and [Vol+] buttons simultaneously for approx. 3
sec. until the status LED lights up continuously.
• Use the device button to select the device to be operated (e.g. [TV]). A
successful selection is confirmed by the status LED flashing once and then
lighting up continuously.
• Enter the code [9] [6] [0], the status LED flashes 2 times and then lights up
permanently.
• Press the "[Ch+]" button. The LED flashes once and then lights up
permanently.
• Press the desired device button (e.g. [STB]). The setting is activated when the
status LED flashes 3 times and then goes out.
6.1.2 To deactivate the channel punch-through function:
• Press and hold the [MUTE] and [Vol+] buttons simultaneously for approx. 3
sec. until the status LED lights up continuously.
• Use the device button to select the device to be operated (e.g. [TV]). A
successful selection is confirmed by the status LED flashing once and then
lighting up continuously.
• Enter the code [9] [6] [0], the status LED flashes 2 times and then lights up
permanently.
• Press the "[Ch+]" button. The LED flashes once and then lights up
permanently.
• Press the desired device button (e.g. [STB]). The setting is deactivated when
the status LED flashes 3 times and then goes out.
Note
• If an invalid code is entered, the status LED flashes 3 times and then lights
up permanently. A new code can then be entered.