Instruction Manual PSx3xxEIP
10
2.5.6. Electrical grounding
Next to the connecting plugs there is a M4 stud bolt. It is recommended to connect
the positioning system with a cable as short as possible to the machine base. The
minimum conductor cross-section for this is 1.5mm².
2.6. Setting of the IP address
The IP address might be provided by 5 different ways:
1) Address assignment via DHCP:
For this purpose set address
99
with the help of the address switches (if present)
before power up the device.
2) Address assignment via BOOTP:
For this purpose set address
98
with the help of the address switches (if present)
before power up the device.
3) Use the last assigned and saved address:
For this purpose set address
97
with the help of the address switches (if present)
before power up the device. Then IP address, netmask and gateway comes out of
the internal EEPROM and will be used if they are
≠ 0.
4) Assign a fixed address with the help of address switches:
For this purpose set an address in the area
1...96
with the help of the address
switches (if present) before power up the device. The following settings will result:
- IP address = 192.168.1.0 + value of address switches
- netmask = 255.255.255.0
- gateway = 0.0.0.0 (nicht verwendet)
5) Use the last address assigning method which has been set by the EIP scanner:
For this purpose set address
0
with the help of the address switches (if present)
before power up the device.
TCP/IP-Objekt; attr. 3 (configuration control) was at last
0
IP address, netmask and gateway comes out of the internal EEPROM and
will be used if they are ≠ 0.
1
Address assignment via BOOTP
2
Address assignment via DHCP
The value of attr. 3 will be stored with each change in the EEPROM and is being
evaluated after the next power-up.
By setting “configuration control” to 0 the IP address which is used actually
(e.g. received by DHCP) can be saved permanently in the EEPROM of the
drive.
Concerning variants with address switches, the IP address which is used
actually (e.g. received by DHCP) can be saved permanently in the
EEPROM of the drive by setting the address switch from a value
≠ 97 to 97
when the drive is powered up.
In the delivery state the address switches (if present) are in switch setting 0, the
default setting of
“configuration control” ist 2.
I.e. in the delivery state the address assignment is always carried out via DHCP.
