71-0149 Hallmark 46 57 SL2 Manual
Date: 12/30/2019
Rev 02
Page 4 of 11
ROOM ASSEMBLY (CONT.)
1.
Place the floor panel in the desired location on a level surface
Note: The floor panel must be level before installing wall and ceiling
panels. If the surface is not level, you may need to shim the bottom
panel to get level.
2.
Interlock the left back panel and right back panel together.
3.
Interlock the left front panel and the left back panel. Interlock the
right front panel and the right back panel.
4.
Place door panel in room and latch to front panels.
5.
Place the ceiling panel on the wall panels.
*Make sure trim of the top panel fits completely around the walls.
Note: Make sure the connection wires from the front right wall and back
wall panel protrude through the hole of the ceiling panel.
6.
Connect the wires in the ceiling panels accessed via flip-up panel as
shown above. There are three access doors. Back Wall and Front Right
Wall.
Note: Match each wire connection to the similar corresponding connector
type.
