71-0149 Hallmark 46 57 SL2 Manual
Date: 12/30/2019
Rev 02
Page 10 of 11
SL2 (SaunaLogic 2) Control Operation
Operating Instructions for Heater
Default settings for temperature are preset to 194°F, the bath time is
set to 60 minutes and 0-minute delay to start to heat. These settings
are adjustable (as described below) from 119°F to 194°F. Length of
sauna can be set from 0 to 60 minutes. The time delay before start
can be up to 24 hours. Any changes are remembered by the heater
for your next bath. Should the heater power be lost then restored,
the settings will return to their default values.
STARTING SAUNA HEATER IMMEDIATELY
Press the control POWER
icon to turn on the sauna control and
heater. The room temperature will be displayed on the control. The
heater will turn on and begin heating the room to current set points.
Once the set temperature is reached inside the room, the control will
turn the heater on and off again as needed to maintain the desired
temperature. At the end of the selected time (60 minutes maximum),
the control will turn itself off and the control display will turn off.
SETTING THE TIME AND TEMPERATURE
To set the sauna length time, press the
icon and then press the
“"+" or "-" icons to increase or decrease time for desired setting. The
maximum of time is 60 minutes.
To set the temperature, press the
and next "+" or "-" icons to increase or decrease temperature for desired
setting. The maximum temperature is 194°F (90°C).
Note: Typical sauna bathing set-point temperature is 150°F to 165°F on the control.
PRE-SET DELAYED START
Press the
icon and delay time will appear in the display and will toggle between “dlay” the amount of time
remaining. The maximum of time is 24 hours. If no delay is desired, press
icon to toggle off the function.
Operating Instructions for Lighting
Press
icon to cycle through lighting options. Press and hold the
icon for 3 seconds to turn off the
lights. Lights will turn off automatically 10 minutes after sauna cycle is completed.
-
Color sequence – White – Red – Green – Blue – Yellow – Aqua – Purple – Rotation of Colors – Off
Choose the color of choice and then set lighting brightness. The brightness will be on display for 3 seconds.
Press the “+” or “-“ icon to increase or decrease the light setting. Setting options are 25, 50, 75, and 100% light
output.
