Daisy Chainable HDBaseT™ Receiver
8
HDBT IN
HDCP
Video Status. Off = No Video detected at the input, Blink = Video detected
with no HDCP, Solid ON = Video detected with HDCP
LINK
Solid on means Sender & Receiver are communicating, Blink = Link has
been established but is in low power mode
STATUS
Used as power indicator
HDBT OUT
HDCP
Video Status. Off = No Video being transmitted, Blink = Video being sent
out with no HDCP, Solid ON = Video output with HDCP
LINK
Solid on means the HDBaseT output of the device is connected to and
communicating with a down-stream Receiver. Blinking means Link has
been established but is in low power mode
L.R.
Used as Long Reach indicator. Means the HDBASET output is operating
in Long Reach mode.
4.3 IR Connections
The extender can extend Infra-red Remote Control signals from the sender to
all the receiver. IR emitter cable is not provided and must be purchased
separately.
IR Emitter (Blaster) Cables
Currently two IR emitter cables are available: CIR-EMT and CIR-EMT2.
CIR-EMT, shown below, is recommended for most applications
IR Emitter Cable CIR-EMT
(Emitter has adhesive backing)
Pin out: Tip=Anode, Ring=Cathode, Sleeve=Not Connected
An alternative Emitter cable is CIR-KIT-EMT2. This cable is better suited for
situations where there is a need to isolate the IR signal to just one TV. It
comes with an adhesive rubber cover can be used to confine the IR beam to
just one target device directly over its IR sensor..
Alternate IR Emitter Cable CIR-EMT2
The CIR-EMT2 has a mono-type plug.
Pin
out: Tip=Anode, Sleeve=Cathode
4.4 Power Connection
The extender requires 5vDC regulated operating voltage. A universal input
(110~240 VAC) external power supply is provided. The UHBX-R-XT features
power input supervisory circuit that protects the device if wrong power supply
is plugged in. But please do not substitute power supplies!
