Daisy Chainable HDBaseT™ Receiver
6
•
Using Cat6 cable, connect the UHBX-R-XT connector labeled HDBT
IN to the HDBaseT signal.from compatible sender.
CAT6 Input and Output Connections
•
If RS-232 output is to be used, connect this port using appropriate
cable to device being controlled. The Pinout of the RS-232 port on
the UHBX-R-XT is as follows:
DB9-M Pin
Term
Direction
2
RX
Input
3
TX
Output
5
GND
Connect a good quality HDMI cable to the HDMI output of the unit to a
display device. The HDMI output connector on the box has a locking nut
above it. Hall Research offers compatible locking HDMI cables.
C-HDMI-L locking HDMI cable
•
If IR Extension is required (from sender to all receivers in daisy
chain), connect an I.R. Emitter cable to the 3.5 mm I.R. EMIT
connector. Recommended IR cable: p/n
CIR-EMT
•
Install a second CAT6 cable into the RJ45 connector on the UHBX-
R-XT and connect the other end of the CAT6 cable to the next
UHBX-R-XT in the chain.
3.2 End Panels
Figure 4 - Connections (UHBX-R-XT shown above)
