Installing the L-807 Wind Cone
Positioning the Swing Arm
After installing the anchor, the swing arm must be correctly positioned. This is
done by performing the following steps.
1.
Using a 9/16" wrench, remove the bottom swing arm bolt and loosen the
top swing arm bolt, see Figure 8.
1
2
HBA118
Figure 8. Positioning the Swing Arm
1. Top Swing Arm Bolt
2. Bottom Swing Arm Bolt
2.
Rotate the swing arm to position as shown in Figure 9.
3.
Place the bottom bolt back through the swing arm.
4.
Tighten both swing arm bolts.
5.
Place the base of the pole onto the anchor, see the following procedure.
Placing the Base of the Pole onto the Anchor
After the swing arm has been positioned, attach the pole to the anchor by per-
forming the following steps.
1.
Verify that the anchor has a 3/4" nut turned onto each of the anchor’s four
corner posts and that they have been leveled, see Figure 6. The four bottom
nuts are used to level the pole. These nuts must be leveled prior to mount-
ing the pole, see “Installing the L-807 Wind Cone Anchor” on page 19.
22
L-807 and L-806 Wind Cone Installation and Maintenance Manual