Tools and Supplies Needed
Tools and Supplies Needed
After all components on the shipping pallet have been inventoried you will
need to accumulate the following tools. These tools are required for assem-
bling the L-807 or L-806 wind cone.
3 4
5
6 7 8
2
1
12
11
10
9
HBA148
Figure 5. Required Tools
1. Anti-Locking Compound
(Used to prevent threaded compo-
nents from seizing)
2. 12" or larger Carpenter Level
(Used to level the anchor)
3. 9/16" Open End Wrench
(Used to install the swing arm bolts)
4. Two 5/8" Open End Wrenches
(Used to secure the hinge bolts)
5. Large Crescent Wrench
(Used to tighten nuts to the anchor
bracket)
6. 1-1/16" Open End Wrench
(Used to level the anchor nuts)
7. 18" Pipe Wrench
(Used to secure external light kit to the pole)
8. 6 ft Ladder
(Used to access hinge on pole)
9. Electrician Tools
(Used to wire lighting kit to power source)
10. 50 ft Fishtape
(Used to route lighting cable to base of pole)
11. Tape Measure
(Used to set anchor height)
12. 3/16" Allen Hex Wrench
( to remove electrical access cover plate)
L-807 and L-806 Wind Cone Installation and Maintenance Manual
17
