HALE SmartFOAM, Description, Installation And Operation Manual

Page: 80 / 102

79
Page 79
SmartFOAM
SETTING PRESETS
The SmartFOAM controller allows the department to
configure up to six foam presets. Each preset allows a
different foam concentrate rate and/or foam tank. If the
foam system is installed on SAM, preset 1 is the default
preset initiated from the SAM Control Center.
Enter the password “1023”. The controller will show the
preset to configure selection screen.
Figure 62: Preset Configuration
Press the button next to the preset to configure (presets
1 through 6) and the display will show the preset configu-
ration screen.
•
Button 1 changes the color of the presets bar
(green, red, orange, purple, blue, or “DISABLED”).
o
“DISABLED” turns the preset OFF and it will not
visible on the preset screen.
•
Button 2 pops-up the onscreen keyboard so that the
presets text can be changed.
•
Button 3 toggles the presets foam tank (tank A or
tank B).
•
Button 5 increases the presets foam concentrate
percentage value.
•
Button 6 decreases the presets foam concentrate
percentage value.
•
Button 7 toggles the “remote activated” value (YES or NO).
o
The SmartFOAM system can be remotely activated / de-
activated with an external switch. When the system is
remotely activated it will use the foam concentrate per-
centage of the preset which has set the “remote acti-
vated?” value to “YES”. Only one preset is able to be
selected for remote activation.
•
The SAVE button saves the presets configuration items to
memory.
•
The RETURN button moves back to the preset to configure
selection screen.
UNIT OF MEASURE
The SmartFOAM controller offers both English and Metric
readouts.
The Hale SmartFOAM system is calibrated at the factory to U.S.
measurement (English) units.
The unit of measure is changed within the USER menu. Enter
the password “1849” to go to the USER menu.
Figure 63: User Menu
There are four items in the USER menu: language, unit of meas-
ure, foam B color, and display format.
1. Move the selection arrow next to the “unit of measure” box
by using the “move selection arrow” UP/DOWN buttons.
2. Use the “select next value” or “select previous value” but-
tons to change the unit of measure (English or Metric).
3. Press the “SAVE” button to save the selection to memory.
4. Press the MENU button to return to the main menu.