HALE SmartFOAM 1.7AHP, Description, Installation And Operation Manual

Page: 53 / 93

Page 52
SmartFOAM
Figure 34 : SmartFOAM Controller Unit Mounting Dimensions
CONTROLLER UNIT
The controller unit mounts in the operator panel of the
apparatus. The display is secured with four #6 pan head
screws and nuts (see Figure 34
: SmartFOAM
Controller Unit Mounting Dimensions ).
The controller requires a 2.0
” (52mm) minimum
clearance from the back of the operator panel to allow
proper connection of cables.
Single tank models refer to Figure 35
: SmartFOAM
Harness Connections
– Single Tank
❑
Connect C1 of the controller harness to the “B”
connector on the rear of the controller unit.
❑
C
onnect C6 of the controller harness to the “C”
connector on the rear of the controller unit.
❑
Connect C13 on the controller harness to C14 of
the pump harness.
❑
Connect C7 of the controller harness to the water
flow sensor input module.
❑
Connect C3 of the controller harness to the water
flow sensor (paddlewheel).
❑
Connect C10 of the pump harness to the low
foam sensor.
❑
C2 and C4 of the controller harness are used for
options (remote start stop and CAN
communication respectively).
❑
C6, C7, C8, C15, and C16 of the pump harness
are pre-connected by Hale Products at the
factory.
Dual tank models refer to Figure 36 : SmartFOAM
Harness Connections
– Dual Tank
❑
Connect C1 of
the controller harness to the “B”
connector on the rear of the controller unit.
❑
C
onnect C6 of the controller harness to the “C”
connector on the rear of the controller unit.
❑
Connect C13 on the controller harness to C14 of
the pump harness.
❑
Connect C7 of the controller harness to the water
flow sensor input module.
❑
Connect C3 of the controller harness to the water
flow sensor (paddlewheel).
❑
Connect C8 of the pump harness to the tank A
selector.
❑
Connect C9 of the pump harness to the tank B
selector.
❑
Connect C10 of the pump harness to the tank A
low foam sensor.
❑
Connect C11 of the pump harness to the tank B
low foam sensor.
❑
C2 and C4 of the controller harness are used for
options (remote start stop and CAN
communication respectively).
❑
C6, C7, C15, and C16 of the pump harness are
pre-connected by Hale Products at the factory.
Notes:
Allow a service loop on the controller
unit’s harness
connections to prevent
“pulling” of the wires or
connectors during body and frame flex.