23
Connecting the trigger
Your MC20/30/50/70 can be turned on
remotely from Standby mode if it is connected
by trigger cable to a control center such as
the Halcro Logic SSP80/100. To activate the
remote On/Standby function:
o
Locate a suitable trigger cable. The
recommended is a maximum length of
three meters of shielded cable. Lengths
longer than this and/or the use of
unshielded cable may result in radio
interference issues.
o
Connect the cable from the trigger input
(6) on the multi-channel power amplifier
to the trigger output on the control center
(SSP).
When connected by trigger
cable, the MC20/30/50/70
cannot be switched to
Standby by selecting the
Standby/On button.
If you require more information, please
contact your dealer.
Connecting to a PC
The MC series of multi-channel power
amplifiers can be connected to a PC or
Network. To connect to the PC/Network:
o
Locate a suitable Ethernet cable (cross-
over cable required for direct PC to MC
unit connections).
o
Connect the cable from the Ethernet
input (7) on the multi-channel power
amplifier to the computer's Ethernet
adaptor.
Connecting the mains supply
cable
Connect the mains supply cable into the unit's
socket (14), which is positioned, at the rear of
the unit.
Continue to read the following pages before
connecting to the mains outlet.
Break-in period
The multi-channel power amplifier electronic
break-in period is completed at the factory. A
further break-in period is not required.