Page 18 of 26
TM
dm8
Volume – balancing function
The volume can be evenly distributed though the speakers or one channel can be louder than
the other. To equalise the outputs of the speakers to the same volume, depress both the L & R
balance buttons (Fig1, 4&7) on the front of the unit at the same time.
Front Panel:
Using either the Balance Control Right (Fig 1, 5) or the Balance Control Left (Fig 1, 2), the user
can change the relative volume for the left and right channels. Depressing the Right button
will increase the volume on the right hand channel and decrease the volume on the left.
To change the overall volume of the unit, use the Volume Control Knob (Fig 1, 7). Turn knob
clockwise to increase the volume and counter-clockwise to decrease the volume. To mute the
system, when the speakers are balanced, continue to turn the knob counter-clockwise until the
word MUTE
appears on the display, or press the Mute switch (Fig 1, 4).
Remote Control
Using the Function key on the remote control the user can change the relative volume for the
left and right channels.
Depress the function key once (Fig 2, 5). The display on the preamplifier (Fig 3) will display
BALANCE
, then use the Volume buttons on the remote control. Depressing the - VOL button
will increase the volume on the left and decrease the volume on the right. Depressing the +
VOL button will increase the volume on the right and decrease the volume on the left.
The volume can be evenly distributed through the speakers or one channel can be louder than
the other. To balance the outputs of the speakers to the same volume, depress both the L & R
(Fig1, 2&5) balance buttons on the front of the unit at the same time.
Switching between sources
To select a device, press the appropriate button on the remote control or turn the selector knob
on the front panel until the device you require appears in the center of the display. After a few
seconds, the center of the display will reverts to displaying the volume level, though the
selected program source will remain on the lower left hand corner of the display. Only
allocated devices are available. Note: The Phono Input is always allocated.
If a source is selected (either through the front panel or remote control) and the correct source
is not selected, ensure that the program button adjacent to the input connectors for the selected
source is illuminated. If it is not, these input connectors will need to be re-allocated, refer to
Connecting signal sources
and
Allocating signal sources and the remote control
, page 19