Page 14 of 26
TM
dm8
Remote Power Amplifier control Output
The dm10 has a remote power amplifier control output (fig 6,15) which will remotely switch
the HALCRO™ amplifiers from Standby to On. Cables can be purchased through HALCRO™
for details please email us at:
.
Bridging
The dm8 will control bridged power amplifiers. For details please email us at:
[email protected] A bridging kit can be purchased through HALCRO™.
Break-in period
The dm8 does not require a break-in period. The electronic break-in period is completed at the
factory.
Programmable Input Selections
The dm8 has seven available pairs of programmable input connectors, three unbalanced, three
balanced voltage inputs and one unbalanced current input. All inputs that have a signal
source connected must be programmed by the remote control. Any input can be programmed
to connect any source. Each button on the remote control can have only one signal source
programmed to it at any time.
Input
Modes
Required output
source impedance
Input impedance
Unbalanced current
input
RCA: Infinite source
impedance
50ohm input impedance
Balanced voltage input
XLR: Low source
impedance
10kohm input
impedance
Unbalanced voltage
input
RCA: Low source
impedance
10kohm input impedance