Hal Communications CWR6850, Instruction Manual

Page: 11 / 64

CHAPTER 2 PAGE 11
To transmit Morse code, connect a shielded cable between the CWR6850 SW.OUT - CW jack and
the CW KEY connection on the transmitter and set the CW level to the desired transmitter power
output. Now, transmit Morse code in the same manner as explained above for RTTY, using the
SEND or AUTO switch positions and "CTRL-A" or "CTRL-X" commands to turn the transmitted data
on or off. The "CTRL-D" command may also be used when transmitting Morse code to give 25 %
extension of the dash length, effectively decreasing the "weight" (and speed) of the transmitted
signal. Set the CWID A / CWID B switch to "A" (button out) for CW identification.
Now that the basic operations of the CWR6850 have been explored, sit back and read the rest of
this manual.