9. ERROR MESSAGE
●
Sensor Error
●
Grip Error
●
Low Temp Error
●
Heater Short Error
●
FATAL Error
EXAMPLE:
350℃ (400℃ - 50℃)
OR
650℉ (750℉
-
100℉)
Set temperature
Set temperature
Low-temperature alarm tolerance
Low-temperature alarm tolerance
EXAMPLE:
Assume that the temperature setting is 400℃/750℉ and the
tolerance 50℃/100℉. If the temperature continues to decrease
and finally falls below the value indicated while the heating
element is on, "Low Temp Error" is displayed.
When there is the possibility that a failure has occurred in the
sensor or heater (including the sensor circuit), "Sensor Error" is
displayed and the power is shut down.
"Grip Error" will be displayed if the connector cord is not attached
to the station OR the wrong handpiece is connected.
If the sensor temperature falls below the difference between the
current temperature setting and the low-temperature alarm
tolerance, "Low Temp Error" is displayed and the warning buzzer
sounds. When the nozzle temperature rises to a value within the
set tolerance, the buzzer will stop sounding.
"Heater Short Error" will flash, and the buzzer will sound
continuously, when an incompatible heater circuit is inserted, or if a
foreign object has found it's way into the connector.
This is displayed when the system is unable to operate normally.
Should this error be displayed, please contact your HAKKO
representative.
29
10. TROUBLE SHOOTING GUIDE
WARNING
Before checking the inside of the HAKKO FR-410 or replacing parts, be sure to disconnect the power
plug. Failure to do so may result in electric shock.
●
Display does not turn
on.
●
Pump does not
operate.
●
Solder is not being
absorbed.
●
The nozzle does not
heat up.
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
Is the power supply cable or connection plug disconnected?
Connect it tightly.
Is the fuse blown?
Replace the fuse. If the fuse blows again,
please send the entire product back to us for repair.
Is the power supply cable or connection plug disconnected?
Connect it tightly.
Is the nozzle or hole in the heating element clogged?
Clean it.
Is the filter pipe full of solder?
Clean it.
Is the ceramic paper Filter hardened?
Replace it with a new one.
Is there a vacuum leak?
Check the connections and filter pipe seals and
replace any worn parts.
Is the heater tube or nozzle clogged?
Clean it.
Is the desoldering gun cord assembly properly connected?
Connect it tightly.
Is the heating element damaged?
Replace it with a new one.
NOTE :
When repairs are needed, please send both the handpiece and the station to
your sales agent.
30