24
2. Disassemble the heating element.
Heating Element
Element Cover
Nozzle
Nut
CAUTION
The heating element is very hot during operation.
Remove the element cover assembly and the nozzle with the attached wrench.
3. Clean out the tube in the heating element
with the provided cleaning pin.
●
Turn the power off after cleaning.
CAUTION
・
Be sure the solder in the tube in the heating element is completely heated, before
cleaning the tube.
・
If the cleaning pin does not pass through the tube in the heating element, replace
the heating element.
Scrape away all oxidation from the tube
in the heating element until the cleaning
pin passes cleanly through the tube.
4. Replace the filters.
●
When the filter pipe is cool to the touch, push down on the release knob at the back
of the handpiece and remove the filter pipe.
●
Examine the seals (front and back holders) at each end of the filter pipe.
Replace : Stiff and/or cracked.
●
Examine the Pre-filter: Remove solder adhering to the waste collector.
●
Examine the ceramic paper filter.
Replace : Ceramic paper filter is showing signs of stains from flux, is stiff,
or contains any solder.
CAUTION
The filter pipe is very hot.
Front holder
Back holder
Ceramic paper
filter
FRONT
Pre-filter
5. Replacement of station filter
If the filer is showing signs of stains
from flux or is stiff, replace it.
Attach the filter as shown in the right
diagram.
Filter case cover
Filter
Filter case cover
(with Filter)
①
②
