7
7. OPERATION
7-1 Network settings
1.
Check that all connections in "
5. INITIAL SETUP
" have been performed and then switch on the
POWER switch of the connection box and switch on the PC.
2.
On the PC, start the IP Address Setting Application.
3.
In the IP Address Setting Application, set the internet protocol setting (IPv4 or IPv6) and input the
IP address, subnet mask, default gateway, and NTP server address, and then click
[Send]
.
Initial network settings
Internet protocol
IPv4
Network mode
Static address
IP address
192.168.1.10
Subnet mask
255.255.255.0
Default gateway
0.0.0.0
NTP server address
Not set
CAUTION
When the POWER switch is turned on while the reset button pressed, the network setting
is initialized.
4.
Press the Reboot button of the connection box more than three seconds.
CAUTION
Changes to the network settings will not be applied until the Reboot button is pressed
for three seconds.
The settings in Step 3 can also be performed during normal operation. In such case as
well, the changes will be applied when the Reboot button is pressed.
When the power supply is turned off without pushing the reboot button, the connection
box may not work normally.
5.
Press the Enter key according to instructions of the application, and confirm that the display of the
application becomes " writing completion".
