![background image](http://html1.mh-extra.com/html/hakko-electronics/fn-1010/fn-1010_instruction-manual_3345757007.webp)
5
5-2-2 Removing tip
1.
As shown in the diagram below,
fit the handpiece (FN1101-81) into the tip
removal attachment of the iron holder.
2.
Fix it by hand so that the soldering iron will not
move
.
Pull the handpiece (FN1101-81) toward
you to remove the tip.
5-2-3 About tips
When a T36 tip is inserted into the handpiece, the station reads the tip information from the wavy-line
section on the following figure.
The tip information can be checked from “Tip Info” on the menu screen.
It is possible to set the details on the “Tip Info” screen. (Refer to
[6-7 Load repetition count alarm]
)
5-3 Station
CAUTION
●
When connecting or disconnecting the soldering iron cord to/from the receptacle, always be sure to
switch the power off first. Failure to do so may result in damage to the circuit board.
●
This equipment has electrostatic discharge countermeasures and must be connected to ground when
in use.
1.
Connect the power cord to the power receptacle
on the back of the station.
Connect the soldering iron cord to the receptacle
on the front of the station.
2.
Place the handpiece in the iron holder.
3.
Plug the power cord plug into an electrical outlet.
When removing, push
in the protruding button
while pulling out.
Receptacle
Tips (T36 series)