11
FM-2
024
24V
-70
W
FM-2
02
4
24V
-70
W
FM
-20
24
24V
-70
W
FM-2024
24V
-70W
FM
-20
24
24V
-70
W
Cleaning the inside of
suction pipe
Move the nozzle cartridge to
the cleaning position indicated
in figure at right. Change the
position of the nozzle cartridge
before turning the power ON, to
prevent accidents.
To clean the inside of the suction
pipe, ensure that the solder
remaining in the pipe has been
completely melted.
For the cleaning of the suction
pipe, set the nozzle temperature
t o 7 5 0 ° F / 4 0 0 ° C o r h i g h e r.
Start this cleaning after the set
temperature has been reached.
To clean the inside of the suction
pipe, insert the cleaning drill fully
into the suction pipe while turning
it clockwise. Then remove the
accumulated debris.
Check and clean the front
and back holder bushings
If foreign matter gets stuck on
the contact surface between the
front holder and the filter pipe
assembly, or between the back
holder bushing and the filter
pipe assembly, air will be sucked
into the tool, preventing normal
desoldering. Remove the solder
and flux adhering to the surface
of front holder (A) and back
holder (B) then connect the filter
pipe assembly.
Caution
If you insert the drill without
turning it or if you try to insert the
drill at an angle, the nozzle cartridge may
be broken.
Caution
Remove the cleaning drill on
axis with the nozzle. If it is difficult to
remove the drill, turn it slightly whilst
withdrawing it. If you forcibly remove the
drill, the cartridge may be broken.
or
(A)
(B)
6. MAINTENANCE
