NOTE:
If power is switched of f or lost during the execution of this
procedure, no data will be entered.
The entire procedure
must be repeated from step 1.
Press the button once.
Press the button once.
Press the or button.
When the station is ON and the
card is in the station, the data entry
procedure follows:
a. Hold the
button down for at least one
second.
b. The current temperature setting will be
displayed, then the
hundreds
digit will begin to
flash. This indicates that the station has
entered the temperature setting mode.
c. Continue with the procedure of 1-4, above.
NOTE:
When the
button is pressed for less than one second,
the current temperature setting is displayed.
●
Replacing the tip
a. Always turn the power OFF when removing
or inserting a tip.
b. Hold the tip with the heat resistant pad and
pull it out.
c. Insert the new tip fully into the Hakko 912. If
the tip is not fully inserted, the display will
show a sensor error
when power is
turned on.
CAUTION:
The tip will be HOT! Use the heat resistant pad to remove
it. Do not hold the tip with the heat resistant pad for an
extended time.
3. Entering the
tens
digit
• Press the
or
button to set the
desired figure.
Any value from 0 to 9 can
be selected.
When the desired figure is
displayed, press the
button to enter .
The
units
digit will begin to flash.
4. Entering the
units
digit
• Press the
or
button to set the
desired figure. When the desired figure is
displayed, press the
button to enter .
The desired temperature is now entered
into the system memory and heater control
will
begin.
8
