NOTE:
Be sure the cleaning sponge is kept CLEAN and DAMP.
A dirty sponge will transfer contaminants to the soldering
tip, reducing thermal efficiency and possibly causing
defective solder joints. A dry sponge will abrade the
soldering tip, reducing its life.
3
2
4
B. Handpiece
1. Insert the tip fully into the handpiece (Hakko
911).
There are no orientation requirements.
2. Pass the iron cord through the hole in the
heat resistant pad.
1
2
4
2. Put the small cleaning sponge in one of the
four holes in the iron holder base.
3. Add water to the level shown in the ac-
companying illustration. The small sponge
will keep the large sponge moist through
capillary action.
4. Wet the large cleaning sponge, squeeze it
dry, and put it on the iron holder base.
Procedure 2-4 – OR –
Wet the large cleaning sponge, squeeze it
dry, and put it on the iron holder base.
5. Place the spare tips in the tip tray.
C. Soldering station
1. Insert the power cord into the receptacle at
the back of the station.
Inser t the soldering iron cord into the
receptacle at the front of the station.
2. Set the iron in the iron holder.
3. Plug the power cord into a grounded wall
socket. The Hakko 941 is protected against
electrostatic discharge and must be
grounded for full efficiency.
To remove the cord,
draw the plug from
the receptacle while
pressing the release pin.
Receptacle
When the plug ‘clicks’,
it is fully inserted.
CAUTION:
Be sure the power switch is OFF before connecting or
disconnecting the soldering iron cord. Failure to do so
may result in damage to the circuit board.