●
When the station enters power save time setting
mode, either
30
or
60
is displayed. Either 30
minutes or 60 minutes can be selected.
●
Pressing the
UP
or
DOWN
button will cause
30
or
60
to be displayed alternately.
●
Press the
button to enter your selection. The
sensor temperature may now be displayed.
Sensor Temperature Display
CAUTION
If the power is turned OFF before the parameter
setting procedure is completed, the new setting
values will not be stored in memory.
●
Initial Reset
Turn the power switch ON while simultane-
ously pressing the
UP
,
DOWN
, and
buttons on the temperature setting section.
The station will be reset to the following
initial values:
●
No data entry is required.
The value displayed is the temperature currently
detected by the sensor.
●
To end parameter input mode, press the
button.
After displaying the temperature setting for two
seconds, the station returns to normal operation.
●
Entering the Parameters
The Hakko 850D has the following three parameters:
1)
°
C or
°
F temperature display selection
2) Power save time (select 30 or 60 minutes)
3) Sensor temperature display
Once the station enters parameter mode, set the
parameters in the order shown below. After all the
parameters have been set, normal operation will be
resumed.
°
C (Celsius) or
°
F (Fahrenheit)
Temperature Display
1. Turn the power switch OFF .
2. Insert the control card into the slot in the unit.
3. Press and hold down the
UP
and
DOWN
buttons on
the temperature setting section simultaneously and
then turn the power switch ON.
3. Continue holding down both buttons until the display
shows
C
(for Celsius) or
F
(for Fahrenheit).
When the display shows
C
or
F
, the station
is in the parameter input mode.
●
Pressing the
UP
or
DOWN
button will cause
C
or
F
to be displayed alternately.
●
Press the
button to select the scale. The power
save time may now be entered.
Power Save Time
The power save function automatically turns
off the hot air when it has blown continuous-
ly for a specified amount of time. Power to
the heater is turned off and then the air is
stopped after the handpiece cools.
°
C/
°
F selection
Power save time
Temperature setting
°
C
30 minutes
300
°
C
PARAMETERS / INITIAL RESETTING
7
