2
SAFETY INSTRUCTIONS
WARNING
Warnings and cautions are placed at critical points in this manual to direct the operator's
attention to significant items. They are defined as follows:
WARNING:
Failure to comply with a WARNING may result in serious injury or death.
CAUTION:
Failure to comply with a CAUTION may result in injury to the operator,
or damage to the items involved. Two examples are given below.
NOTE : A NOTE indicates a procedure or point that is important to the process being describe.
EXAMPLE : AN EXAMPLE is given to demonstrate a particular procedure, point or process.
●
Be sure to comply with following WARNINGS and CAUTIONS for your safety.
WARNING
●
Be sure not to operate the unit with any combination of temperature and air flow settings that
makes the thermal protector trip (the heater lamp turns off during use). This could damage the unit.
CAUTION
When the power is ON, the temperature of the hot air and the nozzle ranges from 100 to 450
°
C
(212 to 842
°
F). To avoid injury to personnel or damage to items in the work area, observe the
following:
●
Do not direct the hot air toward personnel or touch the metal parts near the nozzle.
●
Do not use the product near combustible gases or flammable materials.
●
Advise those in the work area that the unit can reach very high temperatures and should be
considered potentially dangerous.
●
Turn the power OFF when no longer using the Hakko 850D or when leaving it unattended.
●
Before replacing parts or storing the unit, allow the unit to cool and then turn the power OFF.
●
To prevent accidents and failures, be sure to take the following precautions:
●
Do not strike the handpiece against hard surfaces or otherwise subject it to physical shock.
●
Be sure the unit is grounded. Always connect power to a grounded receptacle.
●
Do not disassemble the pump.
●
Do not modify the unit.
●
Use only genuine Hakko replacement parts.
●
Do not bend or damage the control card. If the card does become damaged, do not force the
card into the station slot.
●
Do not wet the unit or use the unit with wet hands.
●
Remove power cord by holding the plug – not the wires.
●
After using, do not turn the power OFF until “P-S”
is displayed on the temperature display.
●
Make sure the work area is well ventilated.
●
The Hakko 850D is not intended for use by children or infirm persons without supervision.
●
Children should be supervised to ensure that they do not play with the Hakko 850D.
