____________________________________________EN________________________________________9
It is recommended to keep the appliance in the original packaging until it is installed on the selected
place, if possible, especially when construction work is performed on the site.
During the removal of the package, please check that the appliance is intact and all necessary parts
are placed in the package. In case of any deficiency or missing parts, please notify the contracted
distributor within the deadline defined by law.
WARNING!
Due to potential danger, please keep packaging material (clips, plastic sacks,
polystyrene foam) away from children.
During handling or transportation of the appliance after its first start up, please keep warnings
on maximum inclination angle described above and ensure that all water has been discharged from
the tank. If the original packaging no longer exists, please provide protection to the appliance and its
parts similar to the original packaging.
3.
TECHNICAL FEATURES
3.1.
Construction features
HB300(C) heat pump water heater is basically composed of an upper part (
Figure
2.7.-1.
)
containing heat pump equipment and a lower part (
Figure
2.7.-2.
) containing the storage tank. The
storage tank of the sanitary hot water- having a volume of
– is covered by an enamel coating
internally and by a thick polyurethane insulation layer having large efficiency externally, and the latter
is covered by plastic surface of the appliance. The pipe radiator, controlling indicator anode electrics
and magnesium indicator anode located on the closing cover are placed on a horizontal axle
common with the closing cover.
The condensate water discharge pipe branch is located in the rear part of the circle-shaped
tray above. The control panel equipped with display is located in the front part. All the other parts of
the heat pump circuit are located above the storage tank according to a precisely planned order,
which produces optimal operation, reduced vibration and noise emission.
The following parts are placed under an easily accessible and adequately insulated plastic
coverage: compressor, thermostatic expansion valve, evaporator, fan ensuring adequate air flow and
all the other parts displayed on Figure
2.7.-1
.
3.2.
Name of parts
Figure 2.7.-1.
Figure 1.5.-2.
Air Outlet
Filter
Air Inlet
Evaporator
Top cover
Electric control box
Compressor
Front Cover
Display
Junction Box Cover
Fan Assy
Rear Cover
Junction Box OUTSIDE USE
