MANOK plus
Safety
16
Order h49 7144.907-333
Hard hat
To protect against falling and projectile parts and materials.
2.5 Particular hazards
The following section names residual risks resulting from the
installation of the product in a machine tool. In all cases, the
residual risks detected during a risk assessment of the ma-
chine tool need to be named by the operator.
Pay attention to the safety instructions named here, as well
as the warning notices in other chapters of these operating
instructions to reduce the risk of health hazards and to pre-
vent dangerous situations.
Moving parts
WARNING
Serious injuries caused by touching rotating
and/or moving parts!
Do not open guards while the system is operating.
During operation, do not reach for rotating and/or
moving parts.
Pay attention to the gap dimensions of moving
parts.
Before opening the guards, ensure that none of
the parts are moving any more.
Stroke
WARNING
Serious crushing injuries caused by the stroke of
the product!
Never reach into an area where moving parts are
operating.
Insufficient workpiece
clamping
DANGER
Serious injuries caused by parts being ejected
centrifugally if level of workpiece clamping is in-
sufficient!
Workpiece blanks must not be outside the clamp-
ing width diameter.
Clamping of the workpiece must not be outside
the defined limits [see »Limits of use« chapter].
Do not exceed the maximum performance values
[see »General information« chapter].
