MANDO G211
Installation
Order h49 7144.907-333
53
WARNING
Serious crushing injuries caused by improper ma-
chine movement during installation!
Never reach into the gap between machine tool,
spindle flange and functional unit.
6. Using the least possible force and speed, move the
drawtube on the machine to its front limit stop [see »Pre-
paring the machine for installation« chapter].
7. Screw in the fixing screws on the functional unit and
tighten to the specified tightening torque [see »Screw
tightening torques« chapter].
8. Unfasten and remove any lifting gear that may have
been required.
9. Remove the mounting aid on a vertically suspended
spindle if one was used.
10. Check face run-out on the test surface of the functional
unit [ideally ≤ 0.01 mm].
11. Check axial run-out on the test surface of the functional
unit [ideally ≤ 0.01 mm].
Whenever the face run-out and/or the axial run-out is greater
than the maximum permitted value:
12. Remove the functional unit.
13. Clean the locating face and the mating faces of the spin-
dle flange and the functional unit.
14. If there is a burr or slight damage, rub down the locating
face of the spindle flange or the functional unit gently
with an oil stone.
15. B Reinstall the functional unit.
16. Repeat the face run-out test.
17. Repeat the axial run-out test.
