Haiku K3150-X0, Installation Manual

Page: 7 / 24

HAIKU ® by Big Ass Fans 3
2.4 m Minimum
to Floor
1 m Minimum
to Obstruction
Before assembling and operating your fan, review the following tips and guidelines to ensure a safe
and easy installation, particularly the safety guidelines on page ii. If you are not completely comfortable
or have questions about any aspect of the installation process, consult a structural engineer or
electrical contractor or contact Haiku Technical Service before beginning installation.
Unpacking the fan
As you remove the fan from its packaging, make sure you are not missing any components required
for assembly and operation. Refer to the fan diagram and the Parts and Hardware section for a list of
components. If you are missing a part required for installation, contact Haiku Technical Service.
If you ordered multiple fans, be sure to keep the components of each fan together! Certain
fan components are not interchangeable.
Determining fan location
Consider the following guidelines as you decide where to install your Haiku:
΄ Do not mount the fan in an environment that is excessively dusty, conductive, corrosive, or gas-filled,
near strong chemicals or solvents, or where there is excessive heat, shock, or vibration.
΄
Do not install the fan near open flames such as those from a gas stove.
΄
The ceiling should be stable with no high vibrations, shaking, or heavy impacts.
΄
Install the fan so that the airfoils are at least 2.4 m above the floor.
΄ Make sure the space around the fan has a clearance of at least 1 m from obstructions such as
cabinets, doors, or lighting fixtures.
΄ The fan can be mounted on ceilings with a slope up to 33° (8:12 pitch) using an extension tube that
is 20 inches (51 cm) or longer. If you are installing the fan with the 7-inch (18-cm) extension tube, the
slope of the ceiling can be no more than 10° (2:12 pitch).
΄
If mounting the fan with the 7-inch (18-cm) extension tube, install the fan where it will be protected
from strong winds.
If
fa
!
P r e pa r at i o n
Tools needed
You will need the following tools to install the fan.
΄
Ladder
΄
#1 Phillips screwdriver
΄
5 mm Hex key (provided)
΄
4 mm Hex key (provided)
΄
Adjustable wrench