49-5000513 Rev. 1
7
ENGLISH
Remote Control Features and Settings
19. HEATER:
(1) When HEAT mode is chosen and is displayed on LCD
display, pressing HEATER button can cancel and set HEATER
function.
(2) Auto mode will not start HEATER function automatically, but
can set or cancel HEATER function.
(3) HEATER function is not available for some units.
20. TIMER:
ON-OFF Operation:
(1) Start the unit and select the desired operating mode.
(2) Press the TIMER OFF button to enter TIMER OFF mode.
The remote control will start flashing "OFF", adjusting time by
+/- button.
(3) Once the desired timer is selected for the unit to turn off,
press the CONFIRM button to confirm this setting.
Cancel TIMER OFF setting:
With a TIMER OFF set,press the CANCEL button once to cancel
the TIMER OFF.
NOTE: Holding the "+/-"button down will rapidly adjust the
time.After replacing batteries or a power failure occurs,the time
setting will need to be reset.
According to the Time setting sequence of TIMER ON or TIMER
OFF, either Start-Stop or Stop-Start can be achieved.
21. +/- Button
+ Every time the button is pressed, the time increases 1 minute.
- Every time the button is pressed, the time decreases 1 minute.
Holding the + or - button down will rapidly adjust the time.
22. CLOCK
Press CLOCK button, AM or PM will flash when remote is in clock
set mode. Use +/- it set mode Use " clos mode. Use M. to adjust
clock and then press CONFIRM to exit set mode.
23. LIGHT
Turns indoor unit display on and off.
24. RESET:
If the remote control is not functioning properly, use a pen point
or similar object to depress this button to reset the remote.
25. LOCK:
Used to lock buttons and LCD display.
26. CODE:
Function reserved.
27. INQUIRE
Function reserved.
Manual Operation (POWER Button) and Maintenance
Manual Operation
• Use the POWER button only when the remote control is lost
or damaged.
• Press the POWER button and the unit will beep once,
indicating start of operation.
• The unit will run automatically in the following modes:
• While in Manual Operation, temperature and fan speed
cannot be changed, nor will it operate in timer or DRY mode.
Inserting the Batteries
1. Remove the battery cover
2. Insert 2 AAA batteries as illustrated
noting battery polarity
3. Reinstall the battery cover
NOTE:
• The distance from the remote control to the receiver should
be less than 23 feet with no obstructions.
• If the remote control display is weak or the operating
distance has diminished, the batteries may need to be
replaced.
• Remote control malfunctions can sometimes be corrected
by removing the batteries from the remote for a few
minutes and then reinstalling them.
• Remove the batteries from the remote control if the unit will
not be in use for an extended period of time. If any segments
of the display remain active after battery removal, press the
reset button.
Optimizing Performance
1. Close doors and windows during operation
2. Do not block the air inlet or outlet
3. Wipe the cabinet using a soft and dry cloth. For serious
stains, use a nuetral detergent diluted with water. Wring the
water out of the cloth before wiping down the unit. Then
wipe off the detergent completely.
Beep
emergency
operation switch
Room
Temperature
Designated
Temperature
Timer
Mode
Fan
Speed
Operation
Mode
Above 73°F
79°F
No
AUTO
COOL
Below 73°F
73°F
No
AUTO
HEAT
<1>
<2>
<3>
