Haier HWM55-918P, User Manual

Page: 14 / 16

Trouble-shooting · Answer to question
When using the child lock function,
if the top cover is opened, the
machine will stop and display E2
alarm. After 15 seconds the machine
will automatic drainage
Clear the E2 alarm, please close the top
cover and press the “START/PAUSE”
button. Then E2 alarm will be cleared.
Phenomena The reason How to settle
The digitron displays E0. The top lid is open during
reserve procedure.
Close the top lid.

The drainage cannot
work, or is too slow. The
digitron displays E1.
Is the drain hose blocked?
Clean the foreign material. Open and

close the top lid once.
It stops running in
midway. The digitron
displays E2.
The top lid is not closed.
Close the top lid.


The safety switch acts,
and the spinning cannot
work. The digitron
displays E3.
Are the laundries put slantingly?
Is the machine slanting?
Reorder the laundries. Close the top lid.

Place the machine horizontally, open
and close the top lid once.

The water fi lling does
not work, or is slow, the
digitron displays E4.
Is the water tap opened, or is
there water supply failure?
Is the water inlet valve blocked?
Is the water pressure too low?
Open the water tap. Open and close the

top lid once.
Clean the water inlet valve then open

and close the top lid once.
Use after the water pressure is normal.

The digitron displays E6.
The digitron displays F2.
The water level sensor is bad. Please contact the after-sales service

department.
Please contact the after-sales service
department.
The
machine
does not
act
Not wash
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset
position?
Please use it when there’s power

supply.
Insert the power plug tightly.

Fill water to the preset position.

Not spin
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set fl at?
Insert the power plug tightly.

Close the top lid.

Set the laundries fl at.

The water tap leaks
There is abnormal sound
inside the machine
Is the screw of the jointer of water
inlet hose loose or awry?
Is the machine slanting?
Are the laundries put slantingly in
spinning?
Are there any foreign materials?
Fasten the screw of the jointer properly.

Adjust the machine to be even
Reorder the laundries and close the top
lid.
Remove the foreign materials.



(If there’s breakdown, please pull off the power plug before checking)
The following phenomenon are not breakdowns sometimes. Please con fi rm again before sending it to
repair.
If there are real breakdowns, please come to the special maintenance department or after-sale
service department of our company. Do not repair it by yourself.
Overflow alarm