9-Installation
Following connections are possible:
9.6.1 Drain hose to sink
▶
Hang the drain hose with the U-support over the
edge of a sink with adequate size (Fig. 9-10).
▶
ping.
9.6.2 Drain hose to waste water connection
▶
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
▶
Put the drain hose for approx 80 mm in the
wastewater pipe.
▶
(Fig. 9-11).
9-10
9-11
CAUTION!
▶
▶
Drain hose is not to be extended. If necessary contact after sales service.
9.6.3 Drain hose to sink connection
▶
The junction must lie above the siphon
▶
A spigot connection is usually closed by a pad
(A)
.
That must be removed to prevent any disfunc
-
tion (Fig. 9-12).
▶
Secure the drain hose with a clamp.
9-12
9.6 Drain Water Connection
Fix the water drain hose properly to the piping. The hose has to reach at one point a height
between 80 and 100 cm above the appliance bottom line! If possible keep always drain
WARNING!
▶
Use only the supplied hose set for the connection.
▶
Never reuse old hose sets!
▶
Only connect to cold water supply.
▶
Before connection, check whether the water is clean and clear.
hose fixed to the clip at the appliance back.
Protect the U-support sufficiently againsy slip-
Attach the U-support and secure it sufficiently
The drain hose should not be submerged in water and should be securely fixed
and leak-free.If the drain hose is placed on the ground or if the pipe is at a hei-
ght of less than 80cm, the washing machine will continuously drain while being
filled(self siphoning).
28