Haier HWD100-BP14636N, User Manual, Page: 28 / 106

10- Installation
EN
28
10.2 Noise reduction pads installation instructions
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environmen-
tally friendly manner.
10.1 Preparation
Take the appliance out of the packaging.
Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port-
hole. This normal phenomenon results from water tests in the factory.
10.3 Dismantle the t
●
ransportation bolts
N
●
ote: Keep in safe place
Keep the transportation bolts in a safe place for later
reinstall the bolts.
10.2.1
Warm tip:
Noise reduction pad is optional , could help to reduce
noise, please assemble it or not according to your own
demand.
2x
2x
10.2.2
noise reduction pads. These are used for reducing
noise(Fig. 10-2.1).
2. Lay the washing machine down to its side, porthole
pointing upwards, bottom side towards operator.
3. Take out the noise reduction pads and remove the
ction pads under the washing machine cabinet as sho-
wn in Figure 10-2.2(two longer pads in position 1and 3,
two shorter pads in position 2 and 4). Finally set the m-
achine upright again.
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
1.
2.
Remove all 4 bolts on the rear side and take out
plastic spacers (Fig. 10-3.1)(Fig. 10-3.2).
Fill left holes with blanking plugs
(Fig. 10-3.3) (Fig. 10-3.4).
10.3.1
10.3.2
10.3.3 10.3.4