Haier HWD100-BD1499U1, User Manual

Page: 43 / 96

EN
11- Installation
43
11.7 Fresh water connection
Make sure that the gaskets are inserted.
1. Connect the water inlet hose with the angled end to
the appliance (Fig. 11.7.1). Tighten the screw joint by
hand.
2. The other end connect to a water tap with a 3/4“
thread (Fig. 11.7.2).
Note: Aquastop system:
The models are equipped with an aquastop inlet hose.The aquastop system protects
against water damage by automatically cutting the fresh water supply in case of a leak-
ing hose. This is indicated by a red marker (A). The hose must be replaced.
WARNING!
▶ Use only the supplied hose set for the connection.
▶ Never reuse old hose sets!
▶ Only connect to cold water supply.
▶ Before connection, check whether the water is clean and clear.
11.8 Electrical Connection
Before each connection check if:
▶ power supply, socket and fusing are appropriate to the rating
plate.
▶ the power socket is earthed and no multi-plug or extension.
▶
the power plug and socket strictly match.
▶
Only UK: The UK plug meets BS1363A standard.
Put the plug into the socket (Fig. 11.8).
WARNING!
▶
Ensure always that all connections (power supply, drain and fresh wa
WHUKRVHDUHnjUP
dry and leak free!
▶
Take care these parts are never to be crushed, kinked, or twisted.
▶
If the supply cord is damaged, it must be replaced by the service agent (see warranty
card) in order to avoid a hazard.
Note: Self Clean
$IWHUHDFKLQVWDOODWLRQRUORQJSHULRGVRIGLVXVHEHIRUHnjUVWXVHDQGIRUUHJXODUPDLQWH
-
nance run programme “Drum Clean” with no load and small amount of detergent or with
special machine cleaner to remove possibly corruptive residues.
11.7.1 11.7.2
11.8