Haier HW80-BP16636, User Manual

Page: 26 / 96

10-Installation
GB
26
10.5 Aligning the appliance
Adjust all feet (Fig. 10-7) to achieve a complete
level position. This will minimize vibrations and thus
noise during use. It will also reduce wear and tear. We
recommend to use a spirit level for adjustment. Floor
should be as stable and fl at as possible.
1. Loose the locknut (1) by using a wrench.
2. Adjust the high by turning the foot (2).
3. Tighten lock ut (1) against the housing.
10-7
Following connections are possible:
10.5.1 Drain hose to sink
▶
Hang the drain hose with the U-support over the
edge of a sink with adequate size (Fig. 10-6).
▶
Protect the U-support suffi ciently against slip-
ping.
10.5.2 Drain hose to waste water connection
▶
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
▶
Put the drain hose for approx. 80 mm in the
wastewater pipe.
▶
Attach the U-support and secure it suffi ciently
(Fig. 10-7).
10.5 Drain Water Connection
Fix the water drain hose properly to the piping. The hose has to reach at one point a
height between 80 and 100 cm above the appliance bottom line! If possible keep always
drain hose fi xed to the clip at the appliance back.
WARNING!
▶
Use only the supplied hose set for the connection.
▶
Never reuse old hose sets!
▶
Only connect to cold water supply.
▶
Before connection, check whether the water is clean and clear.
10-7
10-6