9-Troubleshooting
GB
22
9.2 Troubleshooting with display code
Problem
Cause
Solution
E1
•
Drainage error, water is not fully drained
within 6 minutes
• Clean pump filter.
•
Check drain hose installation.
E2
•
Lock - error.
•
Shut the door properly.
E4
•
Water level not reached after 8 minutes.
•
Drain hose is self-syphoning..
•
Make sure that tap is fully opened and water
pressure is normal.
•
Check drain hose installation.
E8
•
Water protective level - error..
•
Contact the After sales service.
Many occuring problems could be solved by yourself without specific expertise. In case
of a problem please check all shown possibilities and follow below instructions before you
contact an after sales service. See CUSTOMER SERVICE.
WARNING!
▶
Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
▶
Electrical equipment should be serviced only by qualified electrical experts, because
improper repairs can cause considerable consequential damages..
▶
A damaged power cable should only be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
9.1 Information codes
Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code
Message
1
:
25
The remaining wash cycle time will be 1 hour and 25 minutes
6
:
30
The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 min-
utes
P--1
/
2
/
3
1/2/3 additional rinses are choosen (see FUNCTION BUTTONS „Extra rinse“).
End
The washing cycle is finished. The appliance shuts off automatically.
cLo1-
Function child lock is activated
LocI-
Door is closed because of high water level, high water temperature or spinning cy-
cle.
bEEP OFF
The buzzer is deactivated
bEEP ON
The buzzer is activated
SPEEd
u
P
Function “Sped up” is activated
