8-Care and cleaning
GB
20
1.
Turn off and unplug the machine (Fig. 8-8).
2.
Open service flap. You can either use a coin or a
screwdriver (Fig. 8-9).
3.
Provide a flat container to catch leach water
(Fig. 8-10). There could be bigger amounts!
4. Pull the drainhose out and hold its end above the
container (Fig. 8-10).
5. Take the sealing plug out of the drainhose (Fig.
8-10).
6. After complete drainage close drainhose (Fig.
8-11). and push it back into the machine.
7.
Unscrew and remove counter clockwise the pump
filter (Fig. 8-12).
8. Remove contaminants and dirt (Fig. 8-13).
8.5 Long periods of disuse
If the appliance is left idle for a longer period:
1. Pull out the electrical plug (Fig. 8-6).
2.
Turn off water supply (Fig. 8-7).
3. Open the door to prevent formation of moisture
and odours. Let door open while not used.
Before next usage check carefully power cord, water
inlet and drain hose. Make sure everything is properly
installed and without leackage.
WARNING!
Scalding Risk! Water in the pump filter can be very
hot! Before any action please ensure water has
cooled down.
Note: Hygiene
After long periods of disuse we recommended to run programme HYGIENIC with no
load and small amount of detergent in washing agent compartment (2) or special ma-
chine cleaner to remove possibly corruptive residues.
8.6 Pump filter
Clean the filter once a month and check the pump filter
for instanvce if the appliance:
▶
doesn´t drain the water.
▶
doesn´t spin.
▶
cause unusual noise while running.
8-8
8-9
8-6
8-7
8-10
8-11
8-12
8-13
