Haier HCG604W, Installation Instructions And User Manual

Page: 4 / 28

2
Important safety instructions
Installation
Read these instructions carefully before installing or using this product.
Please make this information available to the person responsible for installing the product as it
could reduce your installation costs.
These products are registered:
in New Zealand at www.energysafety.govt.nz and
in Australia with AGA at www.aga.asn.au.
This appliance must be installed in accordance with these installation instructions, local
gas fitting regulations, municipal building codes, water supply regulations, electrical wiring
regulations, AS/NZS 5601.1 - Gas Installations and any other relevant statutory regulations.
Do not modify this appliance.
This appliance is to be installed and serviced only by an authorised person.
Incorrect installation, for which the manufacturer accepts no responsibility, may cause personal
injury or damage.
Always disconnect the cooktop from the mains power supply before carrying out any
maintenance operations or repairs.
In the room where the cooktop is installed, there must be enough air to allow the gas to burn
correctly, according to the current local regulations.
Particular attention shall be given to the relevant requirements regarding ventilation.
This product should not be sealed into the bench with silicone or glue. Doing so will make future
servicing difficult. Haier will not be liable for costs associated with releasing such a product, nor
for repairing damage that may be incurred in doing this.
WARNING!
Cut Hazard
Beware of sharp edges when handling stainless steel appliances.
Failure to use caution could result in injury or cuts.
WARNING!
Electrical Shock Hazard
Before carrying out any work on the electrical section of the appliance, it must
be disconnected from the mains.
Connection to a good earth wiring system is absolutely essential and
mandatory.
Failure to follow this advice may result in death or electrical shock.
Safety and warnings