Haier ES100V-F1(EU), Instruction Manual

Page: 9 / 112

9
Start-up
1
Press to start up.
2
Smart mode
1
2
Use
1.5KW
Smart
3KW
BPS
kW kW
Smart Mode
Enter the single tank mode
Enter the dual tank mode
Bacteria protection system
ON/OFF
Smart mode Pilot light
Single/double tank
Setting Temperature/
Actual temperature
BPS mode Pilot light
Double tank
Single tank
Icons
Keys
Introduction to control panel
After installation, firstly open the tap water inlet valve and the water outlet of the
water heater due to no water in the inner container in the first use, and then open
the mixing valve to allow the maximum hot water flow. Close the water outlet
after continuous flow from the shower nozzle or other water outlets which
indicates that the tank is water-filled. After confirming that all connections are
free of any leak, power it on. If the water heater is powered on first time, the
display is on for 1s, then the water heater goes into the status before power
failure.
If the water heater is powered on, the display is on for 1s, then the water
heater goes into the status before power failure
Press “Smart” to select number of people, and the numerical code is
alternately switched between 1, 2 and 3.
Numerical code 1 is on: for one-person bath;
Numerical code 2 is on: for two-person bath;
Numerical code 3 is on: for three-person bath;
The water heater will automatically complete heating as per the selected
number of people.
50L allows one-person bath and two-person bath;
80L/100L allows one-person bath, two-person bathand three-person bath.
English