Haier ES100V-F1(EU), Instruction Manual

Page: 7 / 112

7
After installation, screw on the drain hose of safety valve.
Warning:
Installation
Model ES50V-F1(EU) ES80V-F1(EU) ES100V-F1(EU)
a
b
c
(
(Figure 1)for installation
reference only.
Hot water
outlet
Safety valve
Cold water inlet
Shower head
Mixing valve
Cold
water
outlet valve
Hot water
outlet valve
Figure 2
170mm
88mm
362mm
170mm
88mm
635mm
170mm
88mm
851mm
The water heater must be installed by the installation personnel from or
appointed by our after-sale service department.
1. The water heater shall be wall mounted.
2. Use a percussion drill to drill 4 holes with a diameter of 12mm and a depth
of 65mm on the wall according to the dimensions as shown in Figure 2;
Insert the expansion bolt into the corresponding wall hole to securely fix the
wall-mounting bracket, and then uplift the water heater to hook the water
heater back on the wall-mounting bracket.
Install the safety valve and other accessories as per the above figure, with
PTFE seal tape used.
To facilitate in assembly and disassembly of the water heater, it is
recommended that the water inlet and outlet pipes be added with G1/2
unions respectively. Confirm the location of water supply, and connect
respectively the the water inlet pipe and the tap water pipe to the water tap.
Fill the inner container with water, and check the water line for any leakage,
if so, connect it again.
Do not lose hold of the water heater until you make sure that the
wall-mounting bracket is reliably hooked, otherwise the water
heater may fall off, resulting in personal injuries or property
damages.
English