Haier AB092ACBHA, Service Manual

Page: 97 / 365

Auto Mode
2
1
Press ON/OFF button
Unit starts running.
The previous status appears on the display
(except. TIMER, SLEEP mode)
Press MODE button. For each press,
operation mode changes as follows:
AUTO COOL DRY FAN HEAT
Select Auto run,
" " appears and auto run starts.
Clock set
When unit is started for the first time
and after replacing batteries in remote
controller, clock should be adjusted as follows:
Press CLOCK button, "AM"or "PM" flashes.
Press or to set correct time. Each press will increase
or decrease 1 min . If the button is kept pressed, time will change quickly.
After time setting is confirmed, press SET, "AM" and "PM"
stop flashing, while clock starts working.
Remote controller's operation
When in use, put the signal transmission head directly to the receiver hole on the indoor unit
The distance between the signal transmission head and the receiver hole should be within 7m without
any obsacles as well.
Don't throw the controller, prevent it from being damaged.
When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wireless telephone
is installed in the room, the receiver is apt to be disturbed in receiving the signal so the distance to the
indoor unit should be shorter.
MODE
SLEEP SWING
CLOCK
TIMER
SET
LOCK LIGHT RESET
2R-03 dry batteries
MIN
UTE
S
HEAT
1
2
3
Confirmation indicator:
In disorderation, reload the batteries or load the new batteries
after 5 mins.
Note:The waster batteries should be disposed properly,use two
new same-type batteries when loading.
If the remote controller can’t function normally or doesn’t work at
all,use a sharp-pointed item to press the reset key.
Hint:Remove the batteries in case unit won’t be in usage for a long period.
If there are any displays after taking-out just need to press reset key.
When throw away the waste batteries, please perform in accordance with the local regulation.
Operation instructions
Loading of the battery
Slightly press " " and push down the cover.
Load the batteries as illustrated.
2 R-03 dry batteries, (cylinder)
Be sure that the loading is in line with the "+"/"-" pole
request as illustrated.
Put on the cover again.
ON
OFF
TEMP
HEALTH
FAN
MODE
SLEEP SWING
CLOCK
TIMER
SET
LOCK LIGHT RESET
2
4
HEAT
1
3
>a__WcU[S^ <[c >a`V[e[a`Wc
-97-