will tell the user that Install mode is active by making the blind
travel down for 1 second before driving back up to the fully up
position. The key can now be released.
The module now thinks it is at the top end stop, but physically
this may not be true. The window blind itself may be only par-
tially up because the mechanism has not yet been aligned to
the electronics. If this is the case just continue to press the UP
KEY until the blind also reaches it’s top end stop. The blind
mechanism and the electronics are now aligned and the key can
be released.
To enter the window size:
Press the Down key to send the blind down and release it when
the bottom end stop is reached. You can either give a short key
press to start the blind going down and another short key press
to stop it at the bottom or you can press and hold the key until
the blind is fully down and then release it. At this point the unit
has timed how long it took to go from fully up to fully down
and recorded this as the window size. It has also set the current
position to be fully down, so it’s important not to press the UP
key again before leaving Install Mode.
To enter the
Haibrain
X-10 address:
Before leaving Install you have to set in the unit’s address. To do
this you just send the X-10 message ‘ADDRESS ON’ or ‘AD-
DRESS OFF’ twice on your chosen House Code (using any
Haibrain
X-10 controller - i.e.: TM13 + RF remote control). Do
not
mix up ‘ON’s and ‘OFF’s. To be accepted, both messages
must
be exactly the same.
To return to RUN mode:
Press the Down Key. The blind will drive UP initially for 2 sec-
10
©
HAIBRAIN
