Hahnel Viper TTL, Instruction Manual

Page: 6 / 40

GB
6
Viper TTL - English
• Only groups A,B or C which are in M or TTL mode will be
adjusted
• Both “Manual” and “TTL” modes can be adjusted
simultaneously by one relevant increment. (i.e. one
increment of manual power may be more than one
increment of TTL FEC compensation)
Multi : Stroboscopic Flash
With stroboscopic flash, a rapid series of flashes are fired.
It can be used to capture multiple images of a moving
subject in a single photo. You can set the firing frequency
25
(number of flashes per second expressed in Hz), the
number of flashes
24
, and the flash output
26
1. Press
A
button for more than 3 seconds so that
<MT> mode is displayed
2. Press <SEL>
02
button and all icons for
A
,
B
and
C
will flash
3. Press
A
button to select <T> the number of times the
flash will flash
• Turn <Adjust Dial>
03
to set the number of flashes
• Press
B
to select “Hz” the flash frequency
• Turn <Adjust Dial>
03
to adjust the frequency of
flashes
4. Press
C
to select the flash output level
• Turn <Adjust Dial>
03
to adjust the output power
• In
<MT>
mode the max power level 1/4
5. Then press button <SEL>
02
to save the setting
Pressing button
A
or
B
or
C
will turn
ON/OFF
each
group
Pressing
button
A
for more than 3 seconds will exit
“MULTI MODE” and return to standard Manual/TTL /OFF
setting
• For “Nikon” version the RPT repeating flash mode is
only available when used with the hahnel Modus 600RT
Speedlight. Check our website www.hahnel.ie for future
firmware updates which may enable this feature when using
the Nikon Viper TTL receiver with original Speedlight’s.
High Speed Sync
Press and hold button
B
to switch on high speed sync -
the icon
20
will switch on. High speed sync applies to all
groups at the same time.
• For “Nikon” version ensure also that the camera setting is
set to 1/320’s (Auto FP) or 1/320’s (Auto FP). Both Viper
transmitter and Camera menu must be set to HSS. Refer
to camera manual for more info.