Models 7180 and 7380
Owner’s Manual
and Installation Guide
5/22/2019
13
Setting and Using the Controller—5B
The controller must be set up correctly for the appliance to perform properly.
Note:
Ensure that the bottom of the controller is firmly locked onto the four tabs on the top of the drive end cap assembly.
Regenerate Button
The Regenerate button is used when starting the water filtration appliance and to start an immediate regeneration. The
Regenerate button can be used in three ways:
1.
The Regenerate button can be used to put the appliance into an immediate regeneration.
A.
Press and hold the Regenerate button for about five seconds until the display changes
from “Regenerate” to
“Going to.”
B.
The appliance is in regeneration mode and will display the status of each cycle. After all regeneration cycles are
complete, the display will return to Normal operating mode.
2.
The Regenerate button can be used to quickly advance through all of the
regeneration cycles to speed up the cycles, which is used when starting up or
diagnosing the appliance only.
A.
To advance through the regeneration cycles, press and hold the Regenerate
button for about five seconds until the displ
ay changes to “Going to.”
B.
The cycle position will display (for example, Backwash 1).
C.
Each cycle can be advanced by pressing the Regenerate button. Always
wait until the cycle position displays before advancing to the next cycle
position.
3.
Press and release the Regenerate button in Normal operating mode to schedule
a regeneration tonight or toggle it off.
Figure 10: Regenerate Button
