z
33
5.3 Manual commissioning/Device setting
Setting mode
Setting
Colour of status LED (5)
Mode 1
Setting alarm limit
lights up white
Mode 2
Establishing radio connection
flashes purple-blue
Mode 3
Calibrating cooker type
flashes yellow-green
Mode 4
Set and test AUX connection
flashes white (normal AUX mode)
flashes red (reversed AUX mode)
Tabele 5. Setting modes
Manual commissioning is necessary if the
cooker was replaced, the cooker dimensions and
mounting height of the sensor unit vary from the
standard values (Figure 8) or if false alarms occur
too frequently.
Manual commissioning is performed via four
setting modes on the sensor unit:
The setting modes can be changed successive-
ly or individually.
Keep the operation button (2) pressed for
5 s.
Setting mode (1) is active. Status LED (5)
lights up white.
Press operation button (3) repeatedly until
next setting mode is reached.
The Status LED (5) signals the set mode in
the appropriate colour.
WARNING!
Risk of accident!
If the setting of the alarm limit is too high, the detection of hazards is delayed.
Do not set alarm limit higher than 8 during the installation!
ç
Colour of
status LED (5)
Number of
acoustic
signals
Alarm limit
Installation
height: Wall
mounting
Installation height:
Installation under the
extractor hood
red
●●● ●●●
12
●●● ●●
11
●●● ●
10
●●●
9
●●
8
●
7*
45 ... 55 cm
blue
●●● ●●●
6
(Standard)*
50 ... 60 cm
55 ... 65 cm
●●● ●●
5*
65 ... 75 cm
●●● ●
4*
75 ... 85 cm
●●●
3
●●
2
●
1
*
recommended alarm limits
Table 6: Alarm limits