hager TXE530, Manual

Page: 41 / 66

TXE530 41 6LE001714A
If there is a domovea system in the installation, the reference date and time will come from this system (priority 1). Otherwise, it is
the weather station that will send the reference date and time (priority 2). And finally, if there are none of these products in the
installation, the reference date and time will be sent by a clock (See the illustration below).
Note: At the end of detection, the configuration tool sends the date and time on the predefined group address Date and time 3,
Time 3 and Date 3. This means that at the end of the scan, the products requiring the date and time are immediately updated.
A request system (Date and time request) was installed for automatic management of the date and time
.
■
Group address
Date 1 30/0/032
Hour 1 30/0/033
Date and time 1 30/0/034
Date 2 30/0/035
Hour 2 30/0/036
Date and time 2 30/0/037
Date 3 30/0/038
Hour 3 30/0/039
Date and time 3 30/0/040
Request Date and time 30/0/041
Domovea
Master Slave Clock
(TX022/TX023/TXA022/TXA023)
Weather station
(TXE530)
Clock
Master/slave
(TX022/TX023/
TXA022/
TXA023)
SUPPLIER CONSUMER
Room controller
(TX450/TX460)
Power manager
(WKT660)
Automatic temperature controller
(WUT08/WUT09/WHT730/
WHT740/WKT510/WKT511
80440100/80660100)
Internet
GPS signal
Date and time 1
Date and time 2
Date and time 3
KNX