33
32
Programming mode exit
>
Step 1: Press the “mode” push button until Prog led is blinking.
>
Step 2: Press “validation” push button. PROG led becomes fixed and access code is displayed.
>
Step 3: Enter access code (1000 factory default) using keypad “left”, “right”, “top” and “bottom”.
>
Step 4: Press “validation” push button to enter programming mode.
>
Step 1: Press the “ESC” push button when not entering any value, to come back to main programming menu.
>
Step 2: Press again on “ESC” push button to exit programming.
>
Step 1: To access required menu, press navigation push buttons “left” and “right”.
>
Step 2: To access parameter to modify press navigation push buttons “top” and “bottom”.
>
Step 3: To modify the parameter, press push button “right” to make the required parameter blinking.
>
Step 4: Press push buttons “top” and “bottom” to increment or decrement the value of the parameter.
>
Step 5: Press “validation” push button to validate.
>
In case of parameter displayed on 2 lines, press “validation” push button after first line modification to
access next one.
>
“ESC” push button allows to come back to main menu or to cancel the modification.
Enter into programming mode
Navigation in programming mode
New Active mode (Automatic or Manual) depends
on information from the master device.
NOTE
PROGRAMMING