END CAP
SLIDE INSERT
HOLD OPEN STOP
MOUNTING
SCREW
Hold Open Stop
Stop Only
Slide Insert
B
21 5/16"
541.3
Pocket Depth 2-1/2"-5"
Mount track 1-1/16"
above top of door to
center of screw holes on
track
SLIDE TRACK
SLIDE ARM
SLIDE ARM INSERT
SCREW
END CAP
PARTS
WITH SLIDE ARM
WITHOUT SLIDE ARM
Installation Sequence:
Use template above to locate mounting holes on pocket wall and mount closer according to pull
1.
side application template. Drill 1/8" pilot holes for the self tapping screws.
Determine door width, adjust spring power of closer by referencing closer installation
2.
instructions.
Fasten closer body to door with power adjustment nut away from hinge.
3.
Fasten slide track to pocket wall face with open side facing down and with hold open stop end
4.
away from hinge edge of door.
Place slide arm on pinion shaft of closer at preload of 45 degrees out from pocket wall.
5.
Secure arm with arm washer and arm screw.
6.
Push arm towards door to pretension closer then secure other end of slide arm to track by
7.
screwing it to the slide insert. Open door to required opening angle. Then slide stop only/hold
open stop up against slider insert and tighten down the stop only/hold open stop via set screw.
Pocket Pivots
6-1/2"
4-1/2" x 4-1/2" Hinges,
Swing Clear Hinges,
or 3/4" Offset Pivots
5"
Dim "B"
Pivot/Hinge Type
INSTALL TRACK ARM - POCKET DOOR APPLICATION 90 OPEN DOOR INTO POCKET
5300 Series Track Arm
Installation Instructions
I-CL00579
REV: 1 REV DATE: 1/11/2014
Page 3 of 3
